2-Person Embroidery Hoop Stand - Make you to complete excellent embroidery works easily ! This large cross-stitch frame stand can be used as two small embroidery stands. You can make 2 embroidery projects at the same time with your friends or family members. Not only for embroidery and needle craft, embroidery stand also could be used as a painting holder, and you could use your creativity to make it more than a hoop holder. Adjusted Upright Pole The pole is composed of two parts. The upper part of the pole can be adjusted to an appropriate angle according to embroidery habits(Rotate 360°), and the distance between the two poles can be freely adjusted by rotating the lower part of the pole(Rotating counterclockwise) 360 Degrees Rotating Design Rotate the hoop 360 degrees to make embroidery more convenient and relaxing. Balance Pad It makes the embroidery frame holder more balanced and has a non-slip effect. Adjustable Embroidery Hoop Size The distance between the two poles can be freely adjusted by rotating the lower part of the pole(Rotating counterclockwise). The embroidery frame holder is suitable for general hoop diameters within 11 inches(29cm). Make Embroidery More Stable When using the embroidery stand to embroider, it does not swing left and right, and it is more firm. The embroidery hoop stand is widely used for DIY embroidery, cross stitch, needlepoint, punch needle kits. Suitable for Two People Embroidery You can not only put the instruction the drawing splint, but also use another clip to place your smartphone to play installation video. Come to make your DIY craft more interesting and relaxing! Installation Steps 1.Install the Vertical Rod Insert the vertical rod into the gap of the base, then put the four-corner nut on the vertical rod screw, and turn clockwise to fix the vertical rod.(Put the balance pads on the four corners of the bottom of the base) 2.Install the Top Clamp Connect the clamp with screws to the top position of the pole.Then tighten and fix it with a wooden screw cap.(Easy to adjust the angle of the clip) 3.Install the Bottom Clamp Put the bottom clamp under the top clamp. Then use wooden screws to fix the upper and lower clips.(The upper and lower spacing can be adjusted according to the thickness of the embroidery hoop) 4.Install the Drawing Support Rod Clamp the drawing support rod into the slot on the top of position of the column, and fix it with a wooden screw cap. 5.Install the Bottom Clip Refer to the third step for installation steps.(As the picture shows) 6.Fix Two Clamps Fix the upper and lower two clips with wooden cylindrical nickel-plated nails where the clips have holes. 7.Install the Embroidery Stretch Insert the elastic copper buckle on the embroidery hoop into the slot of the splint, and then tighten the wooden cylindrical nickel-plated nail. ( Does not swing left and right when embroidering, more firm) 8.Install the Drawing Splint Snap the drawing splint into the drawing splint support rod, and then fix it with galvanized screws.